Pre-treatment and painting systems
Lechler nozzles are an integral part in pre-treatment and painting systems
Nozzles for water jet cleaning
- Use of flat spray nozzles and tongue-type nozzles with eyelet clamps for automated spray jet cleaning.
- Components are treated in different process steps with different liquids (e.g. aqueous / alkaline solutions, deionised water).
- Eductor nozzles are also used under water, the purpose of which is to prevent sedimentation.
Nozzles and installation possibilities of pre-treatment
- Different nozzles available, e.g. MEMOSPRAY or EasyClip.
- Many different possibilities for pipe mounting such as couplings, spacers or end caps are available.
Nozzles for the rinsing zone
- Nozzles are used at the end of the painting line to wash off surplus paint particles mechanically
- This is done according to the cascade principle, i.e. in several stages with increasingly clean rinsing agent until deionised water is used.
Fitting nozzles
Nozzles for water jet cleaning
Series 688/689
Hard, sharp flat fan, narrowly delimited jet pattern. Not prone to clogging.
Applications: Cleaning, washing, degreasing and phosphating, preparation techniques.
Installation possibillities of pre-treatment
MEMOSPRAY nozzle system
Maintaining of the adjusted spray direction by the "memory effect". Very easy handling without the need for special tools. Especially pressure resistant pipe connector.
Easy-Clip nozzle system
Quick and easy assembly with clamp. No tools required. Allround swivelling by 30°. Easy adjustment and cleaning.
Applications: Degreasing, phosphating in surface treatment.